Bren F
The new fluid beat grids are changing the rate of playback if they're played without being pre scanned.
This is on tracks with a clear tempo change.
I'm running the latest released version.
Currently at a gig so this is short.
This is on tracks with a clear tempo change.
I'm running the latest released version.
Currently at a gig so this is short.
geposted 10 hours ago
Bren F
It's happening with tempo transition tracks even if they've been pre-scanned, perhaps not in every case but I can hear it happening on quite a few.
It only happens if sync is pressed (as in BPM match) with the initial values, then it's mangling the track once the tempo changes by slowing down or speeding it up to half or double time.
It only happens if sync is pressed (as in BPM match) with the initial values, then it's mangling the track once the tempo changes by slowing down or speeding it up to half or double time.
geposted 9 hours ago
PhantomDeejay
If you loaded a track on the opossite deck and you pressed sync, then bpm_stabilizer automatically turns on.
You should press sync right before you start mixing your song in that case, not right after you load the song.
However I will pass your usage case to the team for further consideration.
You should press sync right before you start mixing your song in that case, not right after you load the song.
However I will pass your usage case to the team for further consideration.
geposted an hour ago