Hardware Manuals


Pioneer DJ - DDJ-FLX4  

Controls





KEY

ACTION

SHIFT (SECONDARY) ACTION

S SHIFT
Press this button down to access secondary actions as described in the SHIFT ACTION column
1 PLAY
Play-pause loaded track
Play-stutter loaded track
2 Cue
Set a temporary Cue point at current position when track is paused or preview while pressed if Cue point is assigned. Return to this Cue point when track is playing
Jump to the beginning of the track
3 JOG
Touch-sensitive jogwheel for scratching (Vinyl mode enabled), pitch-bending (Vinyl mode disabled) of fine Loop In/Out adjustments. Vinyl mode can be enabled/disabled from VirtualDJ GUI
Fast-searching through loaded track
4 Loop IN
When not in Loop , set current position as the beginning of a Manual Loop . When in Loop , jump to the beginning of the Loop . Hold for more than 2 seconds to trigger a 4 beats auto- Loop .
Enable/disable Loop In Adjust mode. When this mode is enabled and track is in Loop (led blinks), use the jogwheel to fine-adjust the Loop In point.
5 Loop OUT
When not in Loop , set current position as the end of a Manual Loop and trigger the Loop . When in Loop , exits the Loop
Enable/disable Loop Out Adjust mode. When this mode is enabled and track is in Loop (led blinks), use the jogwheel to fine-adjust the Loop In point.
6 RELOOP/EXIT
When in Loop , exits the Loop . When not in Loop , enables the last triggered Loop and jumps to its beginning.
Same action.
7 Cue CALL <
When in Loop , halves the size of the Loop in beats. When not in Loop , loads the previous saved Loop slot or saves it if empty
Delete the current Saved Loop slot.
8 Cue CALL >
When in Loop , doubles the size of the Loop in beats. When not in Loop , loads the next saved Loop slot or saves it if empty
Saves a Loop of the selected beats in size to an empty Saved Loop slot.
9 BEAT SYNC
Syncs deck with the opposite one (matches BPM and phase) or with the Master -Deck (if more than 2 decks). Press for more than 2 seconds to set a Deck as Master -Deck.
Selects the next available % range for Pitch
10 PITCH
Adjust the tempo/pitch of the deck.
.
11 PADS
12 PAD MODES
13 CROSSFADER
Blends audio between the Left and Right assigned decks
Additional function: If Fader Start is enabled, start deck when reach its side, and stop if reaches the other side. See Settings
14 DECK LEVEL
Adjust the Output volume of the Left/Right assigned deck.
Additional function: If Fader Start is enabled, start deck when fader is moving from the zero position to a higher one and stop the deck when fader reaches zero/minimum position. See Settings
15 Cue /PFL
Sends left/right deck's audio (pre-fader) signal to Headphones channel, for pre-listening
.
16 CFX
Apply the selected Color FX (by default High-Low pass Filter) to Left/Right deck. When in middle position, no Color FX is applied.
.
17 Smart COLOR FX
When enabled, the Gain/Trim of Left/Right Deck will be temporary set to minimum when the Color FX knobs reach at the left/right edges, offering additional mute to the applied Color FX
18 EQUALIZER
Adjust the Low, Mid and High frequencies of the Left/Right assigned deck.
Note The device is offering Full Stems controls. See details at EQ Modes
.
19 TRIM
Adjust the applied Gain. When in middle position, the applied gain is following the zeroDB VDJ setting value.
20 VU METER
The leds indicate the level of the Left/Right decks..
21 LOAD
Loads the selected track from Browser to Left/Right decks
Left LOAD : sets Sideview as focused Browser window.
Right LOAD : Cycles Sideview view (Automix, Sidelist , Sampler, Karaoke and Shortcuts)
22 BROWSE
Scroll through files/folders. Push to toggle focus between Folders and Tracks Lists in Browser
Push to set focus to Folders List.. If focus is in Folders List, open/close sub-folders
23 MIC LEVEL
Adjust the level of the Microphone input signal.
24 PHONES MIX
Blends audio in Headphones, between the Decks that their PFL/CUE is enabled and the Master Output (if the Master Cue /PFL is enabled).
25 PHONES LEVEL
Adjust the Volume of the Headphones output.
26 Smart FADER
Enable/disable Smart Fader mode. When enabled (led turned on) :
- The BPM of the other (non-live) Deck will be matched to the playing one.
- When crossfading between the 2 Decks, both Decks will have the same BPM and at the end of the transition, both Decks will have the BPM of the other Deck.
- The levels of EQ LOW will be automatically altered during the transition
- An Echo Out Mix FX will be applied at the end of the transition.
Same as the non-SHIFT action with the difference of the Reverb Mix FX applied instead of Echo Out (led will blink)
27 Master LEVEL
Adjust the Volume of the Master output.
28 Master Cue
When enabled, sends audio signal from the Master Output to Headphones channel (PHONES MIX knob needs to be at a position higher to minimum.
29 FX ASSIGN
Select the Deck (1=Left, 2=Right or 1&2=both Left & Right) to which the selected Effect will apply to
30 FX SELECT
Select the next available Effect for the selected Deck(s)
Select the previous available Effect for the selected Deck(s)
31 BEAT <>
Select the previous/next size in beats for the selected Beat-aware Effect
Left button to re-analyze Track
Right button to manual tap the Track's BPM
32 FX LEVEL
Adjust the 1st Parameter of the selected Effect
33 FX ON
Triggers the selected Effect to the selected Deck(s)

Front & Rear