FILTER. Press this button to enable/disable the Filter effect on this deck.
ECHO. Press this button to enable/disable the Echo effect on this deck
TRANS. Press this button to enable/disable the Beat Grid effect on this deck
SKID. Press this button to enable/disable the Backspin effect on this deck
PHASE. Press this button to enable/disable the Phaser effect on this deck
FLANGER. Press this button to enable/disable the Flanger effect on this deck
PAN. Press this button to enable/disable the Reverb effect on this deck
HOLD. Press this button to enable/disable the temporary effect mode. If enabled (led will blink), the triggered effects will act temporary (while pressed) Note: If the HOLD button is held for more than 2 seconds, the unit will enter in HOLD mode and none of the functions will operate, until the same button is pressed and held again.
TIME. Use this encoder to adjust the 1st parameter of the selected/last triggered Effect. Hold TAP(S) down and then use this encoder to adjust the 3rd parameter of the same effect. Push the encoder to open/close the GUI of the selected/last triggered effect.
RATIO (same encoder as 28). If the Sampler mode is not selected, use this encoder to adjust the 2nd parameter of the selected/last triggered Effect. Hold TAP(S) down and then use this encoder to adjust the 4th parameter of the same effect. Push the encoder to open/close the GUI of the selected/last triggered effect
