FRONT & REAR PANELS

Pioneer XDJ-XZ - Rear panel

74 LINK

PRO DJ Link (Ethernet) connections for Rekordbox mode. These connections are not used from VirtualDJ

75 USB

This USB connection sends and receives audio and control information from a connected computer.

76 BOOTH OUT

Balanced Booth Output. Connect your Booth monitor speaker to this socket, using 1/4" TRS cables. The level of this output is controlled by the BOOTH LEVEL knob at the top panel

77 Master 1 OUT

Balanced Master Output. Connect your powered speakers or power amp here using XLR type cables. The level of this output is controlled by the Master LEVEL knob at the top panel

78 Master 2 OUT

Alternative Un-Balanced Master Output. Connect your powered speakers or power amp here using RCA type cables. The level of this output is controlled by the Master LEVEL knob at the top panel

79 SEND

Outputs the sound from the channel specified with the BEAT FX channel selector switch to the external device such as a DJ Sampler.

Pioneer XDJ-XZ - Rear panel

80 CH4 INPUT

These sockets input sound to Mixer channel 4 and supports both LINE and PHONO type devices. The signal of this input will go through the CH4 of the XDJ-XZ if the CH4 INPUT source selector (top panel) is set to either LINE or PHONO. This input is also part of the USB Audio Interface, and can be used for Timecode -DVS control. See Advanced Setup.

81 CH3 INPUT

These sockets input sound to Mixer channel 3 and supports both LINE and PHONO type devices. The signal of this input will go through the CH3 of the XDJ-XZ if the CH3 INPUT source selector (top panel) is set to either LINE or PHONO. This input is also part of the USB Audio Interface, and can be used for Timecode -DVS control. See Advanced Setup.

82 AUX INPUT

Use this socket to connect an external media source, such as Media player, CD Player, i-Pod, Smart -Phone etc The signal of this input is routed to the Master Output if the AUX source selector at the top panel is set to LINE/PORTABLE and can be turn on/off and adjust its Volume from the top panel (AUX and AUX TRIM)

83 MIC 1 / MIC 2 INPUT

Connect up to 2 microphones to these sockets using XLR or TRS plugs. The output levels of these Inputs are controlled from the top panel

84 AC IN

Use the provided AC cable to connect XDJ-XZ to a power outlet.

85 POWER

Use this Switch to power the unit on and off. Turn on XDJ-XZ after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off the XDJ-XZ

Pioneer XDJ-XZ - Front panel

86 PHONES SOCKET

Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring. The level of this output is controlled from the top panel