Forum: VirtualDJ Skins
skin for numark...
Topic: skin for numark mixtrack pro 2 - Page: 1
geposted Sun 23 Jun 13 @ 2:50 pm
However what worries me are those 3 Modes the lower Pads have.
Can you please check something for me ?.. When launching VirtualDJ, does the unit always enter the 1st Mode ? In other words, if you select the 2nd mode, and then launch VirtualDj, is it on 2nd mode still, or the unit initializes with the 1st mode ?
geposted Sun 23 Jun 13 @ 3:38 pm
geposted Sun 23 Jun 13 @ 6:34 pm
geposted Sun 23 Jun 13 @ 7:59 pm
geposted Sat 13 Jul 13 @ 6:07 am
geposted Sat 13 Jul 13 @ 11:35 am
Please read my posts above and provide me the feedback i need ;)
geposted Sun 14 Jul 13 @ 12:36 am
I made the test :
If I quit Virtual DJ in "mode 3" and restarted the programme, it's stayed in "mode 3"
If I quit Virtual DJ in "mode 3" and I disconnected the usb cable of the console, and replug it, I restart Virtual DJ, it's in "mode 1"
I hope it will help you
geposted Tue 16 Jul 13 @ 11:25 am
geposted Tue 16 Jul 13 @ 4:39 pm
geposted Mon 22 Jul 13 @ 4:52 am
geposted Fri 26 Jul 13 @ 11:58 am
geposted Tue 30 Jul 13 @ 4:28 am
Numark Mixtrack Pro II
Audio & Video View
based on the default mapper
1366x768 1440x900 1600x900
Download Link :
Have fun ;)
geposted Sun 04 Aug 13 @ 4:16 pm
geposted Mon 05 Aug 13 @ 4:50 am
- The Video VIEW is enabled from the small VIDEO button you will see in the Center (Mixer) of the skin
- The 3 Modes of the lower PADs are changing by a "Hardware" way, so the skin can not tell which mode you have selected. I could change the mapper and provide some variables, but it wouldnt change much, as when you restart VirtualDj, it doesnt always start on Mode 1.
So the low pads of the skin, may not light up , the same way as the actual controller.
since i dont have the unit (skinning in blind), let me know of any issues/comments
geposted Mon 05 Aug 13 @ 7:40 am
geposted Wed 07 Aug 13 @ 8:02 am
geposted Wed 07 Aug 13 @ 9:57 am
geposted Fri 09 Aug 13 @ 11:01 pm
geposted Wed 21 Aug 13 @ 10:38 am
geposted Wed 21 Aug 13 @ 12:10 pm