Effekte

With the EFFECTS section of the DJM-S5 you can apply software VirtualDJ Effects, select an Effects Bank, apply a Scratch Cutter Pattern, choose a Crossfader Curve etc



The Effects assigned to the 6 FX Slots of VirtualDJ can be selected from the GUI.


VirtualDJ - 6 Fx Slots layout

KEY

ACTION

SHIFT (SECONDARY) ACTION

10 FX1 | CUT1

Select the 1st FX Slot

Invert the Volume Faders

11 FX2 | CUT2

Select the 2nd FX Slot

Select Smooth/Linear Curve for the Crossfader

12 FX3 | CUT3

Select the 3rd FX Slot

Select Scratch /Cut Curve for the Crossfader

13 FX1 | CUT4

Select the 4th FX Slot

Enable/disable the Crossfader Hotcue mode. When enabled, Track will jump to the selected Hotcue each time the Crossfader moves from one side to the other.

14 FX2 | CUT5

Select the 5th FX Slot

Loads the Effects saved to FX Bank A

15 FX3 | CUT6

Select the 6th FX Slot

Loads the Effects saved to FX Bank B

16 LEVER

Apply the selected (from the FX|CUT buttons) VirtualDJ Effects to the assigned Left/Right deck.

17 BEAT

Half/double the Beats of the VirtualDJ Effects of all 6 FX Slots simultaneously (if available)

18 FX LEVEL/DEPTH

Adjust the 1st Parameter of the VirtualDJ Effects of all 6 FX Slots simultaneously

Multiple Effects can be selected and applied when more than 1 FX|CUT button are pressed

Scratch CUTTER

Press and hold one of the 6 FX | CUT buttons for more than 1 second to enable the Scratch Cutter mode and select one of the 6 pre-defined patterns. The led of the selected Scratch Cutter will be lit solid, while all other 5 buttons will be turned off.
While Scratch Cutter mode is enabled, use the 6 FX | CUT buttons to select a different pattern.
To disable the Scratch Cutter mode, press and hold any of the 6 FX | CUT buttons.

Apply the selected Scratch Cutter pattern to Left/Right Deck by turning on the Left/Right LEVER paddle.

Start scratching - moving the platter back and forth on beat (or other timing). For some patterns, you can select the BEAT < for double speed or BEAT > for normal speed.
The Scratch Cutter patterns can be applied using any controller with touch-sensitive jogwheels or DVS ( Timecode Vinyl/CD).

While Scratch Cutter mode is selected, you can also apply VirtualDJ Effects by holding MODE button and selecting a FX Slot with the FX | CUT buttons.

See https://www.youtube.com/watch?v=2-qYtIfsC6Y