Hardware Manuals


Rane - TTM57 MKII - Layout  

Equalizer & Source Selector




  1. LOW. Full-cut isolator to adjust the low (bass) frequencies of each Mixer channel.

  2. MID. Full-cut isolator to adjust the middle (mid) frequencies of each Mixer channel

  3. HIGH. Full-cut isolator to adjust the high (treble) frequencies of each Mixer channel.

  4. GAIN. Adjusts the input audio level (trim) up to +15db of the left and right Mixer channel. No boost or cut is at 12 o’clock position.

  5. KILL LOW. Temporary (as long as its pressed) full cut of the low (bass) frequencies of each Mixer channel.

  6. KILL MID. Temporary (as long as its pressed) full cut of the middle (mid) frequencies of each Mixer channel.

  7. KILL HIGH. Temporary (as long as its pressed) full cut of the high (treble) frequencies of each Mixer channel.

  8. FLEXFX. Use this button to route the Output to external Hardware FX unit (connections at the rear side). If no Send-Return FX unit is connected to the rear side, the sound from the software will be muted.

  9. FILTER. Applies a High-Pass / Low-Pass Filter on each Mixer channel.

  10. SOURCE SEL. Set this selector to the appropriate position to define which Channel Input will be routed to the 2 Mixer Channel Outputs (DECK 1 and DECK 2).

    On USB A or USB B position, the audio signal from the computer connected to the USB A or USB B port (rear panel) will be routed to the Output of this Mixer Channel and assign the MIDI controls for the Left or Right channels to the same computer.

    On INPUTS PH/CD, AUX the audio signal from the relative Inputs will be routed directly to the Output of this Mixer Channel. In this case the sound from the computer’s decks will be muted. Use these positions to route external analogue media sources or the PH/CD.


Inputs