Hardware Manuals


Pioneer DJ - DDJ-FLX10 - Layout  

FRONT & REAR PANELS








  1. Master OUT1: Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers.

  2. Master OUT2: Master signal output connectors (RCA – Unbalanced). Use it to connect with another Mixer , or consumer grade amplifier.

  3. BOOTH OUT: Booth signal output (TRS – Balanced). The strength of the signal is controlled by “BOOTH MONITOR LEVEL” knob (14) on the Mixer section. Use it to connect your booth speakers, or an amp that needs different sound output level than Master output.

  4. CH4 INPUTS: Connect an analog source on CH4 of the DDJ-FLX10 Mixer . You can connect a turntable or a CD-Player. The input is selectable via the LINE/PHONO switcher

  5. CH2 INPUT: Connect an analog source on CH2 of DDJ-FLX10 Mixer . You can only connect a CD-Player, or a similar line level device.

  6. CH1 INPUT: Connect an analog source on CH1 of DDJ-FLX10 Mixer . You can only connect a CD-Player, or a similar line level device.

  7. CH3 INPUTS: Connect an analog source on CH3 of the DDJ-FLX10 Mixer . You can connect a turntable or a CD-Player. The input is selectable via the LINE/PHONO switcher

  8. DMX OUT: This output is not used by VirtualDJ

  9. USB: Use a standard USB-C cable to connect DDJ-FLX10 with your computer. Select USB A or USB B from the top panel Source selectors to control VirtualDJ Decks.

  10. MIC 2 INPUT: Connect a mic on the DDJ-FLX10 Mixer . You can use only a Jack (TRS) connector.

  11. MIC 1 INPUT: Connect a mic on the DDJ-FLX10 Mixer . You can use XLR or Jack (TRS) connectors.

  12. POWER SWITCH: Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.

  13. DC INPUT: Connect the supplied PSU.

  14. HEADPHONES CONNECTOR: Connect your headphones. Both sizes (3.5mm and 6.35mm ( 1⁄4 in)) are offered.