bradleys
Hi,
I'm trying to set up my EKS Otus with VDJ Pro 6.1. It works fine to control VDJ, but the status LEDs aren't good. It does update the LEDs (in a slightly odd way), but after 3 seconds everything reverts back to all LEDs being on.
Having read the EKS document on MIDI mappings, this is probably because after 3 seconds of not receiving any status updates from the software/driver it reverts back to firmware control of the LEDs.
I'm not actually bothered about having VDJ control the LEDs anyway, so is there any way I can configure it to be controlled by the Otus but not send any status updates to it at all, so that the Otus' firmware will handle the LEDs?
I'm trying to set up my EKS Otus with VDJ Pro 6.1. It works fine to control VDJ, but the status LEDs aren't good. It does update the LEDs (in a slightly odd way), but after 3 seconds everything reverts back to all LEDs being on.
Having read the EKS document on MIDI mappings, this is probably because after 3 seconds of not receiving any status updates from the software/driver it reverts back to firmware control of the LEDs.
I'm not actually bothered about having VDJ control the LEDs anyway, so is there any way I can configure it to be controlled by the Otus but not send any status updates to it at all, so that the Otus' firmware will handle the LEDs?
geposted Tue 25 May 10 @ 4:07 pm