impal864
Just bought a set of new timecodes and a new turntables with mixer and cant get the TC value to 100%. On the wave forms it only goes in about 1/4 of the way in the advanced view. I have tried to use auto config and the values still jump around, but still only 1/4 of the way of the window. I have a pictures if needed to explain more.
geposted Fri 09 May 08 @ 12:13 pm
jimmy b
If you get 100% timecode signal and the audio sounds good, then don't worry.
geposted Fri 09 May 08 @ 12:37 pm
impal864
Thanks for the response.
The signal jumps around from 50%-100%, is that normal should I worry about quality or latency?
The signal jumps around from 50%-100%, is that normal should I worry about quality or latency?
geposted Fri 09 May 08 @ 2:26 pm
fullblast22
also make sure your tcvs and cartridges are clean.
geposted Thu 15 May 08 @ 6:37 am
jimmy b
impal864 wrote :
Thanks for the response.
The signal jumps around from 50%-100%
The signal jumps around from 50%-100%
Try this, Check Software RIAA Preamp (Timecode config>advance view) and see what you get.
I Checked that and my signal is solid at 100%.
geposted Thu 15 May 08 @ 8:58 am
impal864
Ok so I just ordered some new shure m44-7 needles in hopes that would help...
Also what is the best way to clean the TCV's?
Also what is the best way to clean the TCV's?
geposted Mon 19 May 08 @ 10:43 pm
DJ-ALF
For cleaning you can find solution that is special made for cleaning records.
geposted Tue 20 May 08 @ 12:31 pm