Mixer CONTROLS

KEY

ACTION

17 CROSSFADER

Blends audio between the left and right assigned decks

18 VU METERS

The Left/Right series of Leds indicate the pre-fader output level of Left/Right Deck.

19 VOLUME

Adjust the Output Volume of the Left/Right Deck.

20 Cue (PFL)

Select Left/Right Deck to send to the Headphones Channel for pre-listening.

21 Mixer FX PARAM

Adjust the 1st (Strength)) Parameter of the selected Color FX. When at middle position, no Effect is applied.

22 Mixer FX SELECT (1-4)

Select and enable/disable a Mixer (Color) Effect.
Button 1 : Filter, Button 2 - Echo, Button 3 : Noise, Button 4 : Flanger.

23 3 BAND EQ

Adjust the Low (Bass), Mid and High (Treble) Equalizer frequencies of the Left/Right Deck

24 GAIN

Adjust the pre-fader output level of the Left/Right Deck

25 QUANT

Enable/disable Quantize mode on both Left and Right Decks. When enabled, hotcues, play, Loop etc will be snapped (quantized) to 1 Beat or other value as defined in the VirtualDJ globalQuantize setting

26 Master

Adjust the level of the Master Output (connection at the rear panel).
Hardware operation (output volume is controlled by the hardware), but position will be visible on VirtualDJ GUI (fake mode)

27 MIC

Turn Microphone input On/Off (connection at the rear panel). The volume of the Microphone Input is controlled from the rear panel

28 SAMPLER VOL

Adjust the Output Master Volume of the VirtualDJ Sampler

29 Cue MIX

Blends Master Output signal and audio signals from PFLed Decks to the Headphones Output. When at minimum position, only Decks that have the PFL/CUE enabled, will be heard to the Headphones. When at maximum position, only the Master Output will be heard in Headphones

30 Cue VOL

Adjust the Output Volume of the Headphones Channel (connection at the front panel).
Hardware Operation (Headphones Volume is controlled from the Hardware), but its position and value will be also shown at the VirtualDJ GUI (fake mode)

Pads