HEADPHONES CONNECTOR: Connect your headphones. Both sizes (3.5mm and 6.35mm ( 1⁄4 in)) are offered.
DC INPUT: Connect the supplied PSU.
POWER SWITCH: Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.
BOOTH OUT: Booth signal output (TRS – Balanced). The strength of the signal is controlled by “BOOTH MONITOR LEVEL” knob (15) on the Mixer section. Use it to connect your booth speakers, or an amp that needs different sound output level than Master output.
Master OUT2: Master signal output connectors (RCA – Unbalanced). Use it to connect with another Mixer , or consumer grade amplifier.
Master OUT1: Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers.
CH2 INPUT: Connect an analog source on CH2 of the DDJ-800 Mixer . You can connect a turntable or a CD-Player. The input is selectable via “INPUT SELECT SWITCH” (9) on the Mixer section. Depending on whether you connect a turntable or a cd-player please remember to adjust the phono/line switch accordingly.
GND SCREW: Use it to screw your GND (ground) cable from turntables that provide it in order to eliminate GND static noise.
CH1 INPUT: Connect an analog source on CH1 of the DDJ-800 Mixer . You can connect a turntable or a CD-Player. The input is selectable via “INPUT SELECT SWITCH” (9) on the Mixer section. Depending on whether you connect a turntable or a cd-player please remember to adjust the phono/line switch accordingly.
MIC 1 INPUT: Connect a mic on the DDJ-800 Mixer . You can use XLR or Jack (TRS) connectors.
MIC 2 INPUT: Connect a mic on the DDJ-800 Mixer . You can only use a Jack (TRS) connector.
AUX INPUT: Connect a line level device such as another Mixer . The level of this input is controlled by "AUX LEVEL" (19) knob on the Mixer section.
USB CONNECTOR: Use a standard USB cable to connect DDJ-800 with your computer.
