Akiyama Pulsar Front Panel 42 MIC INPUT Connect a Microphone via the 1/4" socket 43 MIC LEVEL Adjust the Level of the Microphone Input 44 MIC ON/OFF Turn on/off the Microphone Input 45 TOUCH SENSITIVE Adjust the Touch sensitivity of the Left and Right Jogwheel 46 XF CURVE Adjust the slope (curve) of the Crossfader (from Scratch -Cut to Smooth) 47 PFL MIX Blends audio signals in Headphones Channel between the Master Output (when in maximum-right position) and the Decks that have been selected (with PFL) 48 PFL LEVEL Adjust the Output Volume of the Headphones Channel 49 HEADPHONES Connect your Headphones to either the 1/4" or the 1/8" socket Akiyama Pulsar Rear Panel 50 DC Optionally use a proper power 6V DC Power Adapter to connect the unit to a power outlet.Note that the unit can operate with USB Power as well 51 POWER Power on/off switcher. Power on the unit after all other connections are done 52 USB Connect the unit to a USB port of your computer using the provided USB cable 53 Master OUT TRS Connect your amplifier (speakers) to this balanced Output using TRS 1/8" cables. The level of this output is controlled by the Master knob at the top panel of the unit 54 Master OUT RCA Connect your amplifier (speakers) to this unbalanced Output using standard RCA cables. The level of this output is controlled by the Master knob at the top panel of the unit 55 56 INPUTS Connect your audio sources to these inputs and can accept both line and phono-level signals. 57 PC/THRU Use the PC/THRU switcher to send all Inputs directly to the Master out (THRU) and mute the software output or to VirtualDJ (PC). See Advanced Setup 59 AUX CD players, MP3 Player, Tablet Pad and other line level instruments may only be connected to this jack. Input volume will be controlled by the channel fader. The channel INPUT1 (36) selector switch must be in the "AUX". 58 AUX GAIN Adjust the Output Level of the Auxiiary Input.