FRONT & REAR PANELS

KEY

DESCRIPTION

41 HEADPHONES SOCKET

Connect your Headphones using a 1/4" or/and a 1/8" cable or adapter. The Volume of the Headphones channel is controlled from the top panel of the unit

42 CROSSFADER ASSIGN

Assign each deck to the left (A) or the right (B) side of the crossfader. Put the switcher on the middle position (Off) if you want to disable the crossfader for one or more decks

43 MIC2 INPUT

Connect a Microphone * using a 1/4" cable or adapter.

44 MIC2 LEVEL

Control the volume of MIC2 input

45 MIC2 TONE

Apply a simple single band EQ on MIC2 input

46 POWER

Connect the provided PSU and press the POWER button to turn on the unit

47 USB

Connect the NS4FX with a USB port of your computer, using the provided USB cable

48 Master OUTPUT

Connect your amplifier or amplified speakers using proper XLR cables. The Level of this Output is controlled from the top panel of the unit

49 BOOTH OUTPUT

Connect a second amplifier or another set of amplified speakers using proper RCA cables. The Level of this Output is controlled from the top panel of the unit

43 AUX INPUT

Connect a device that provides "Line level" audio signal. The Level of this Input is controlled from the top panel of the unit

43 MIC1 INPUT

Connect a Microphone * using a 1/4" cable or adapter. The Level of this Input is controlled from the top panel of the unit

* Note : The Microphone Inputs along with the AUX input are directly routed to the Master Output of the NS4FX. The inputs are not available in the USB Audio Interface, therefore they cannot be included in the Audio Setup nor can be recorded directly. However, recording your mix along with the Microphone Input is possible via Record LoopBack

For further Technical features and specifications, visit
Numark NS4FX
Product's Page

Hardware Integration Department 2022 - ATOMIX PRODUCTIONS

Reproduction of this manual in full or in part without written permission from Atomix Productions is prohibited.