Master OUT BALANCED Balanced Master Output. Connect your powered speakers or power amp here using XLR type cables. The level of this output is controlled by the Master LEVEL knob at the top panel
Master OUT 2 Alternative Un-Balanced Master Output. Connect your powered speakers or power amp here using RCA type cables. The level of this output is controlled by the Master LEVEL knob at the top panel
BOOTH OUT Balanced Booth Output. Connect your Booth monitor speaker to this socket, using 1/4" TRS cables. The level of this output is controlled by the BOOTH MONITOR knob at the top panel
USB. This USB connection sends and receives audio and control information from a connected computer.
INPUTS (CH 1) These sockets input sound to Mixer channel 1 and supports both LINE and PHONO devices. The signal of this input will go through the CH1 of the XDJ-RX2 if the Source selector (top panel) is set to either LINE or PHONO. This input is not part of the USB Audio Interface, thus the XDJ-RX2 doesnt support Timecode -DVS.
INPUTS (CH 2) These sockets input sound to Mixer channel 2 and supports both LINE and PHONO devices. The signal of this input will go through the CH2 of the XDJ-RX2 if the Source selector (top panel) is set to either LINE or PHONO. This input is not part of the USB Audio Interface, thus the XDJ-RX2 doesnt support Timecode -DVS.
AUX Use this socket to connect an external media source, such as Media player, CD Player, i-Pod, Smart -Phone etc The signal of this input ir routed to the Master Output and can turn on/off and adjust its Volume from the top panel (AUX and AUX TRIM)
2 x MIC INPUT2. Connect your microphones to these socket using XLR or TRS plugs. The output levels of these Inputs are controlled from the top panel
POWER: Use the provided AC cable to connect XDJ-RX2 to a power outlet. Use the Power Switch (above the socket) to turn the unit on and off. Turn on XDJ-RX2 after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off the XDJ-RX2
HEADPHONES SOCKET. Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring. The level of this output is controlled from the top panel
