Master OUT1: Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers.
Master OUT2: Master signal output connectors (RCA – Unbalanced). Use it to connect with another Mixer , or consumer grade amplifier.
BOOTH OUT: Booth signal output (TRS – Balanced). The strength of the signal is controlled by “BOOTH MONITOR LEVEL” knob (15) on the Mixer section. Use it to connect your booth speakers, or an amp that needs different sound output level than Master output.
GND SCREW: Use it to screw your GND (ground) cable from turntables that provide it in order to eliminate GND static noise.
CH4 INPUTS: Connect an analog source on CH4 of the DDJ-RZ Mixer . You can connect a turntable or a CD-Player. The input is selectable via “INPUT SELECT SWITCH” (10) on the Mixer section
CH2 INPUT: Connect an analog source on CH2 of DDJ-RZ Mixer . You can only connect a CD-Player, or a similar line level device.
CH1 INPUT: Connect an analog source on CH1 of DDJ-RZ Mixer . You can only connect a CD-Player, or a similar line level device.
CH3 INPUTS: Connect an analog source on CH3 of the DDJ-RZ Mixer . You can connect a turntable or a CD-Player.
MIC 1 INPUT: Connect a mic on the DDJ-RZ Mixer . You can use XLR or Jack (TRS) connectors.
MIC 2 INPUT: Connect a mic on the DDJ-RZ Mixer . You can use only a Jack (TRS) connector.
USB B CONNECTOR: Use a standard USB cable to connect DDJ-RZ with your computer.
USB A CONNECTOR: Use a standard USB cable to connect DDJ-RZ with your computer.
POWER SWITCH: Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.
AC INPUT: Connect an IEC power supply cable
HEADPHONES CONNECTOR: Connect your headphones. Both sizes (3.5mm and 6.35mm ( 1⁄4 in)) are offered.
CROSSFADER CURVE ADJUST: Adjusts the curve of the crossfader
