EFFECT CONTROLS

The Rane Seventy offers the ability to apply Hardware (Flex) and software (VirtualDJ) Effects on left/right Mixer channel.
Use the FLEX/SOFTWARE FX button to toggle between the 2 modes. Arm/Select the Effects you wish to trigger via the 6 labeled buttons, then use the latch on/off-temporary switches to apply the armed Effects to left/right Mixer channel. All the information about the Effects will be displayed on the LCD of the Rane Seventy.

KEY

ACTION

SHIFT (SECONDARY) ACTION

21 LCD

The Display will show the names of the Effects for Slots 1-3 on both sides (and highlighted if armed), the BPM of Left/Right Decks and the Beats value of the Effect from FX Slot 1.

22 FX SELECT

In Flex FX mode:
Use these buttons to arm/select the Hardware effects you wish to turn on/off. All 6 Hardware Effects - as printed on silkscreen - can be enabled on both Mixer channels, but it's a single selection, so only one can be selected/armed and enabled each time.

In Software FX mode:
Use these buttons to arm/select the VirtualDJ Effects you wish to turn on/off. The left 3 buttons represent the 3 VirtualDJ FX slots of Left Deck and can be applied only to Left Deck, while the 3 right buttons represent the 3 VirtualDJ FX Slots of Right deck and can be applied on Right deck only. All 3 Effects per Deck can be armed and enabled at the same time

In Flex FX mode:
Enable a mode where the Parameters of the Hardware Effects can be changed

In Software FX mode:
Enable the Selection mode (led will blink). When enabled, use the TIME encoder to select a different Effect on the FX slot that this mode is enabled.

23 FX MODE

Toggle between Flex FX (Hardware Effects - led lit in blue) and Software FX mode (VirtualDJ Effects - led will be lit in orange).

24 FX ON/LOCK

Enable/disable the armed(selected) Effects to Left/Right Mixer Channel. Move the latch switcher down to apply the Effect(s) temporary or move up for toggling.

25 TIME

Adjust the 2nd Parameter of the Effect (usually the Beats Parameter) on Left or Right Deck, depending on the arrow indicator you see on the LCD

26 BEAT

Move the joystick up/down to increase/decrease the Beats of the Effect on Left or Right Deck, depending on the arrow indicator you see on the LCD
Move the joystick left/right to select which side the BEATS and the Joystick will affect (notice the arrow on the LCD)

Move to any direction to access the Utilities/Settings menu of the Device.

27 DEPTH

Adjust the 1st Parameter of the Effect (usually the Wet/Dry - Frequency Parameter) on Left/Right Deck

28 TAP

Manually Tap on tempo to define Track's tempo in case it has not been properly calculated by VirtualDJ

Open/close the device Settings/Utilities menu