Mixer , EQUALIZER & OTHER IN/OUT CONTROLS

KEY

ACTION

1 CROSSFADER

Blends audio between left and right Mixer channels

2 VOLUME

Adjust the Volume of each Mixer channel.

3 Cue CROSSFADER

Blend the pre-fader audio signal from Left and Right Mixer channels to the Headphones Output. When set to far left, only the Left channel will be heard in Headphones and when set to far right, only the Right channel will be heard to Headphones

4 Cue MIX

Blends the audio that's being sent on the headphones channel between the headphones signal (far left) and the Master output signal (far right).

5 Cue LEVEL

Adjusts the volume of the headphones channel.

6 EQ LOW

Adjust the low (bass) frequencies of left/right Mixer channel.

7 EQ MID

Adjust the mid (middle) frequencies of left/right Mixer channel.

8 EQ HIGH

Adjust the high (treble) frequencies of left/right Mixer channel.

9 LP/HP FILTER

Apply a Low/High-pass Filter to left/right Mixer channel. When centered, no Filter is applied.

10 LEVEL

Adjusts the audio level (gain) of left/right Mixer channel.

11 SOURCE SELECT

Select the input source of Left/Right Mixer channel. Put the switchers to USB A or USB B position for sending Left/Right VirtualDJ Deck to Left/Right Mixer channels.

12 MAIN LEVEL

Adjusts the volume of the Master output of the device (connection at the rear panel).

13 BOOTH LEVEL

Adjusts the volume of the Booth output of the device (connection at the rear panel).

14 SESSION IN

Adjusts the volume of the incoming signal on "Session" input on the rear panel of the device.

15 SESSION OUT

Adjusts the volume of the "Session" output (connection at the rear panel of the device).

16 SESSION Cue

When enabled, sends the signal of the "Session" input to the headphones channel for pre-listening..

17 MIC LEVEL

Adjust the volume of the Microphone 1 input (connection at the rear panel of the device)

18 MIC TONE

Adjust the tone (single band equalizer) of the Microphone 1 input (connection at the rear panel of the device)

19 MIC ON

Turn on/off the signal of the Microphone 1 input (connection at the rear panel of the device)

20 MIC ECHO

Applies an Echo effect on the Microphone 1 input

Please note that all these operations are hardware operated, but the movement of some of them will be visible in VirtualDJ GUI.

Effekte